Difference between revisions of "Changing Robot Parameters"
m (Peter moved page Changing Robot Parameter to Changing Robot Parameters: typo) |
|||
| Line 1: | Line 1: | ||
| − | CPRog uses different robot specific | + | CPRog uses different robot specific parameters, e.g. maximum allowable joint velocities or the minimum and maximum allowable joint motion. These parameter are defined in XML files and can be adapted to the specific needs. |
[[file:caution.png|frameless|50px]] | [[file:caution.png|frameless|50px]] | ||
| Line 7: | Line 7: | ||
| − | + | =Location of the parameter file= | |
| − | + | [[File:CPRog_RobotParameterFile.PNG|500px|thumb|Example robot-parameters-file]] | |
| − | + | The files containing the robot parameters are located in the robot directory in c:\CPRog\Data\Robots, e.g.: | |
| − | + | C:\CPRog\Data\Robots\igus_5DOF_BV\igus_5DOF_BV.xml | |
| − | The robot | + | To find out, which file you are using you can have a look at which file is referenced in your current project file [[Robot Files and Project Files#Which project file am I currently using?]] |
| − | C:\CPRog\Data\Robots\igus_5DOF_BV\igus_5DOF_BV.xml | ||
These XML files can be opened with any text editor. | These XML files can be opened with any text editor. | ||
Revision as of 21:17, 15 May 2018
CPRog uses different robot specific parameters, e.g. maximum allowable joint velocities or the minimum and maximum allowable joint motion. These parameter are defined in XML files and can be adapted to the specific needs.
!!!
Please be aware that changing these parameter might lead to collisions and other problems! Change the parameter with care and in small increments. Perform tests after the changes.
!!!
Location of the parameter file
The files containing the robot parameters are located in the robot directory in c:\CPRog\Data\Robots, e.g.:
C:\CPRog\Data\Robots\igus_5DOF_BV\igus_5DOF_BV.xml
To find out, which file you are using you can have a look at which file is referenced in your current project file Robot Files and Project Files#Which project file am I currently using?
These XML files can be opened with any text editor. Changes take effect after changing the file and restarting CPRog.
Attention: Follow the English number notation and use "." as separator, not ","!
2. Joint velocity
Line 37 with the tag "JointVelocities" defines the maximum rotational velocitiy of each joint in °/s.
Pay attention to:
- During manual jogging only 50% of this velocity is allowed. The full velocity is reached during replay with 100% in a program.
- When increasing the velocity problems may occur:
- Overcurrent Error when the current consumption is too high
- Position Lag Error when the joints PID controller cannot reach the set point commands fast enough
With the Config Software ModuleCtrl it is possible to adapt the joint modules parameter, either to set them higher, or to disable the error by setting to zero.
3. Joint min/max travel limits
Line 36 with the tag "SoftwareMinMax" defines the allowed motion ranges for the joints. It is not possible in CPRog to move the joint out of these limits.
Pay attention to:
- When increasing these limits collisions might occur that have been prevented before!
For questions or comments please get in contact with us.
