Difference between revisions of "Rebel Joint"
(→Manual) |
|||
| Line 4: | Line 4: | ||
Product user guide: (will follow soon). | Product user guide: (will follow soon). | ||
| − | Documentation of the motor controller: [https://cpr-robots.com/download/ | + | Documentation of the motor controller in |
| + | |||
| + | EN: [https://cpr-robots.com/download/DocumentationEN/BLDCBoard_UserGuide_iRC_V0-7_en.pdf BLDCBoardUserGuide_V0-7_en.pdf] | ||
| + | |||
| + | DE: [https://cpr-robots.com/download/DocumentationEN/BLDCBoard_UserGuide_iRC_V0-7_de.pdf BLDCBoardUserGuide_V0-7_de.pdf] | ||
| + | |||
This document contains dimensions, pin-outs, behavior and the description of the parameter. The communication protocol is described below. | This document contains dimensions, pin-outs, behavior and the description of the parameter. The communication protocol is described below. | ||
Revision as of 16:22, 26 August 2021
This page provides information and first steps support on the igus Rebel joint modules.
Manual
Product user guide: (will follow soon).
Documentation of the motor controller in
EN: BLDCBoardUserGuide_V0-7_en.pdf
DE: BLDCBoardUserGuide_V0-7_de.pdf
This document contains dimensions, pin-outs, behavior and the description of the parameter. The communication protocol is described below.
Test and Configuration Software
The software tool "ModuleControl" allows to move a single joint in different operations modes. It also allows to change the motion parameter on the board. ModuleControl needs a USB to CAN adapter from PeakSysteme, the PCAN-USB.
Download: ModuleControlClosedLoop
Communication Protocol
The motor controller uses a CAN based custom protocol called CPRCANV2. This simple protocol sends and receives 32 bit position information. CANopen ist not supported.
Protocol specification: CPRCANV2 protocol specification
Demo Source Code
A C# VisualStudio2019 solution is available to show the basic communication with a Rebel joint. This demo code makes use of the Peak Systeme PCAN-USB adapter. The demo source code lies on github: CANV2ProtocolDemoClient
Contact
In case of questions please contact Alexander Mühlens at igus GmbH.
