Difference between revisions of "Rebel Joint"

From Wiki
m (Removed update date)
m (fixed typo)
 
Line 25: Line 25:
  
 
=Demo Source Code=
 
=Demo Source Code=
A C# VisualStudio2019 solution is available to show the basic communication with a Rebel joint. This demo code makes use of the Peak Systeme PCAN-USB adapter.
+
A C# Visual Studio 2019 solution is available to show the basic communication with a Rebel joint. This demo code makes use of the Peak Systeme PCAN-USB adapter.
 
The demo source code lies on github: [https://github.com/CommonplaceRobotics/CANV2ProtocolDemoClient CANV2ProtocolDemoClient]
 
The demo source code lies on github: [https://github.com/CommonplaceRobotics/CANV2ProtocolDemoClient CANV2ProtocolDemoClient]
  
 
=Contact=
 
=Contact=
 
In case of questions please contact [mailto:amuehlens@igus.net Alexander Mühlens] at igus GmbH.
 
In case of questions please contact [mailto:amuehlens@igus.net Alexander Mühlens] at igus GmbH.

Latest revision as of 08:30, 15 August 2022

This page provides information and first steps support on the igus Rebel joint modules.

Manual

Documentation for the ReBeL robot arms:

Documentation for the motor controller:

This document contains dimensions, pin-outs, behavior and the description of the parameter. The communication protocol is described below.

Test and Configuration Software

The software tool "ModuleControl" allows to move a single joint in different operations modes. It also allows to change the motion parameter on the board. ModuleControl needs a USB to CAN adapter from PeakSysteme, the PCAN-USB.

Please download the software at the ModuleControl wiki page, please use the ClosedLoop-Version: Config Software ModuleCtrl

Communication Protocol

The motor controller uses a CAN based custom protocol called CPRCANV2. This simple protocol sends and receives 32 bit position information. CANopen ist not supported.

Protocol specification:

Demo Source Code

A C# Visual Studio 2019 solution is available to show the basic communication with a Rebel joint. This demo code makes use of the Peak Systeme PCAN-USB adapter. The demo source code lies on github: CANV2ProtocolDemoClient

Contact

In case of questions please contact Alexander Mühlens at igus GmbH.