Difference between revisions of "Additional DIO-Boards of the DCi Control Electronics"
From Wiki
(Created page with "The DCi Robot is shipped with one DIO module as standard. Should you require additional digital inputs and outputs, two additional DIO modules can be added. The hardware insta...") |
|||
Line 4: | Line 4: | ||
# Turn off the robot and disconnect from power source. | # Turn off the robot and disconnect from power source. | ||
# Turn the robot on its side. Once flipped one its side. You will see the electronics modules installed in the robot. | # Turn the robot on its side. Once flipped one its side. You will see the electronics modules installed in the robot. | ||
− | # If there is only the standard DIO module installed, set | + | # If there is only the standard DIO module installed, bridge the second pin-set of header K5 as shown in figure 1.[[file:DCi_second_DIOmodule.png|thumb|200px]] |
Revision as of 10:00, 21 November 2018
The DCi Robot is shipped with one DIO module as standard. Should you require additional digital inputs and outputs, two additional DIO modules can be added. The hardware installation is simple, however, you need to get access to the underside of the robot.
Hardware installation
- Bring the robot into the referencing position, so that you can later turn it on its side.
- Turn off the robot and disconnect from power source.
- Turn the robot on its side. Once flipped one its side. You will see the electronics modules installed in the robot.
- If there is only the standard DIO module installed, bridge the second pin-set of header K5 as shown in figure 1.