Template:Connect DCi Robot/TinyCtrl to a Laptop via LAN

From Wiki
Revision as of 14:20, 14 August 2018 by Peter (talk | contribs)

To establish a connection between Linux embedded control (DCi Robot) and PC, the Networkadapter of the PC has to be configured for an IP in the address range 192.168.3.0/24. I usually chose IP address 192.168.3.1 as shown below.

PC IP 192.168.3.1, subnet 255.255.255.0
  • Power off the robot. Disconnect the power supply from mains power.
  • Plug the LAN cable into the right LAN socket at the DCi robot and into your Windows computer on the other end.
  • Power on the Robot, disengage emergency stop.
  • Wait until the Green LEDs of the stepper motor boards at the back of the robot start blinking.
  • Start CPRog and open the correct project file for your robot. Currently there are two versions in the field:
    • DCi with output encoder
    • DCi with motor encoder

This is how you recognize them 

click Connect, reset, enable. The robot should now be ready for referencing, which can be done via the Teach Pendant. However, since CProg is already running, I would now reference the Robot in CPRog (but that's just personal preference).


Retrieved from "http://wiki.cpr-robots.com/index.php?title=Template:Connect_DCi_Robot/TinyCtrl_to_a_Laptop_via_LAN&oldid=1691"