Motor Brake

Caution! Not Hot Plugging! Disconnect the control from power before working on it. Test the brake functionality before releasing the robot to normal operation.

Motor Brake

Motor brakes are used to prevent robot from falling down or collapsing when there is no motor torque, e.g. in the case of an emergency stop. They are used in gantry and SCARA robots z-axis.

Necessary Connections

Two additional relays and several connections are required to integrate a brake properly.

Please see the following schematics: iRC_CircuitDiagram_48V_EN.pdf - to be extended!

Necessary Software Configuration

The following settings have to be done in the iRC while the robot is connected:

• Enable the brake and set the according digital out: normally DOut21
• Enable the E-Stop monitoring and set the according digital in: normally DIn21
• Apply and save the changes