How to operate an electrical parallel gripper using CPRog and the Modular Control Electronics

From Wiki

Application

The PG01 is a timing-controlled, electrical parallel gripper. It is mainly used in educational applications and not suitable for manufacturing.

The Gripper operates on +24V DC supply voltage and 24V signal voltage.

  • If the signal is high, the gripper motor will turn over for a set amount of time to open the jaws.
  • If the signal is low, the gripper motor will turn over for a set amount of time to close the jaws.

After the gripper has closed a small holding current thrugh the motor will ensure that the gripper grips the object.

Mechanical Integration

Robolink parallel gripper mount.png
  • The gripper is fixed with M4 screws to the flange of the robolink robot arm.
  • The cable to the gripper has to be routed, so that it does not catch or get stuck during operation.


Elektrische connections

The gripper cable has to be routed via the cable ducts of the robolink robot and must be strain relieved.

Robolink parallel gripper electrical supply.png
Retrieved from "http://wiki.cpr-robots.com/index.php?title=How_to_operate_an_electrical_parallel_gripper_using_CPRog_and_the_Modular_Control_Electronics&oldid=1346"