|
|
| (25 intermediate revisions by one other user not shown) |
| Line 1: |
Line 1: |
| − | | + | #REDIRECT [[Motion Smoothing]] |
| − | [[file:MotionSmoothing.png]] | |
| − | Motion commands are adapt to follow the joint accelerations. This can be done for a single motion command, but also for a combination of up to 10 commands.
| |
| − | Then it is also possible to smooth the corners. This allows the robot to go through the corner with a remaining velocity. If there is not corner smoothing active the robot stops at every corner for a short moment. This leads to a more abrupt motion.
| |
| − |
| |
| − | Parameter:
| |
| − | • Acc: Percentage of the possible acceleration, 0 .. 100
| |
| − | • Smooth: Scop of smoothing in percent, 0..100
| |
| − | | |
| − | Non-motion commands like “Wait” or “DOut” interrupts the smooting of a motion set. So if a very short wait (e.g. 0.1s) is inserted between two motion commands, there will be no smoothing.
| |
