|
|
| (19 intermediate revisions by one other user not shown) |
| Line 1: |
Line 1: |
| − | The "smooth" parameter in the CPRog Program editor allows the smoothing of motion commands as depicted below:
| + | #REDIRECT [[Motion Smoothing]] |
| − | | |
| − | [[file:MotionSmoothingGraphic.png]][[file:MotionNoSmoothingGrafic.png]] | |
| − | | |
| − | =High accelerations=
| |
| − | Motion commands are smoothed by CPRog, while taking into account the joint accelerations defined by the "acc" parameter in the program editor. | |
| − | | |
| − | When a value other than 0 % is entered as "smooth" paramter of the motion command corners will be smoothed. This allows the robot to go through the corner at a constant velocity. If corner smoothing is inactive (0 %), the robot stops at every corner. This leads to a more abrupt motion.
| |
| − |
| |
| − | Parameters:
| |
| − | *Acc: Percentage of allowed maximum acceleration, 0...100%
| |
| − | *Smooth: Amount of smoothing in percent, 0...100%
| |
| − | | |
| − | [[file:MotionSmoothing.png|MotionSmoothing.png]]
| |
| − | | |
| − | Non-motion commands like "Wait" or "DOut" interrupt the smoothing of a motion set. So if a very short wait (e.g. 0.1s) is inserted between two motion commands, there will be no smoothing.
| |
