|
|
| (102 intermediate revisions by 2 users not shown) |
| Line 1: |
Line 1: |
| − | The name of the configuration file that you need to use in CPRog for your robot is composed as follows. Use the table below to identify the
| + | #REDIRECT [[Configuration Files Overview]] |
| − | filename:
| |
| − | In general, any configuration file is comprised like this <code> <#><IGUS_DQ_arm/IGUS_arm>_<4DOF/5DOF>_<SV/BV>_<AE/ME>.prj </code>
| |
| − | | |
| − | {| class="wikitable"
| |
| − | |-
| |
| − | ! Igus robolink DQ arm or Igus robolink D arm?
| |
| − | |<IGUS_DQ_arm/IGUS_arm>|
| |
| − | | There are several types or robolink robot arms, the most common is the D arm, named just “IGUS arm” || [[file:igus_d_dq.png|200px|frameless]]
| |
| − | |-
| |
| − | ! 4 DOF or 5 Glossary?
| |
| − | |<4DOF/5DOF>|
| |
| − | | DOF is the acronym for “degrees of freedom”, meaning the number of robot joints. The robot on the right is 5 DOF. Note: the white gripper is not counted.|| [[file:robolink_DOF.png|200px|frameless]]
| |
| − | |-
| |
| − | !BV or SV?
| |
| − | |<SV/BV>|
| |
| − | | BV stands for Big Version with 2.5 kg payload. SV stands for Small Version with 0.5 kg payload. Measure the diameter of joint 2. 5cm = BV; 3cm = SV || [[file:robolink_BVSV.png|200px|frameless]]
| |
| − | |-
| |
| − | ! AE or ME?
| |
| − | |<AE/ME>|
| |
| − | |ME versions use a motor encoder, AE version use a encoder on the gear output. Count the number of sockets of any of the modules labelled "Stepper Motor Driver Module" on the DIN Rail. 4 sockets = ME; 3 sockets = AE ||[[file:DINrail_AEME.png|200px|frameless]]
| |
| − | |}
| |
| − | | |
| − | | |
| − | ==
| |
