Difference between revisions of "Acceleration and Motion Smoothing"
From Wiki
| Line 12: | Line 12: | ||
*Smooth: Amount of smoothing in percent, 0...100% | *Smooth: Amount of smoothing in percent, 0...100% | ||
| − | [[file:MotionSmoothing.png| | + | [[file:MotionSmoothing.png|610px|thumb|center|Smoothing enabled to various degrees]][[file:NoMotionSmoothing.png|thumb|center|600px|No motion smoothing]] |
Non-motion commands like "Wait" or "DOut" interrupt the smoothing of a motion set. So if a very short wait (e.g. 0.1s) is inserted between two motion commands, there will be no smoothing. | Non-motion commands like "Wait" or "DOut" interrupt the smoothing of a motion set. So if a very short wait (e.g. 0.1s) is inserted between two motion commands, there will be no smoothing. | ||
Revision as of 13:49, 9 July 2018
The "smooth" parameter in the CPRog Program editor allows the smoothing of motion commands as depicted below:
High accelerations
Motion commands are smoothed by CPRog, while taking into account the joint accelerations defined by the "acc" parameter in the program editor.
When a value other than 0 % is entered as "smooth" paramter of the motion command corners will be smoothed. This allows the robot to go through the corner at a constant velocity. If corner smoothing is inactive (0 %), the robot stops at every corner. This leads to a more abrupt motion.
Parameters:
- Acc: Percentage of allowed maximum acceleration, 0...100%
- Smooth: Amount of smoothing in percent, 0...100%
File:MotionSmoothing.png
Smoothing enabled to various degrees
File:NoMotionSmoothing.png
No motion smoothing
Non-motion commands like "Wait" or "DOut" interrupt the smoothing of a motion set. So if a very short wait (e.g. 0.1s) is inserted between two motion commands, there will be no smoothing.
