Robot Hardware Troubleshooting
From Wiki
| Problem | Cause | Correction | |
|---|---|---|---|
| Excessively jerky movement or acceleration and stall of the last joint of a robolink robot during initial set up of the robot | Wrong encoder direction | Swap encoder direction of this joint | |
| Green LEDs on the rail modules are off | No power is supplied to the Modules | Check the power supply and the fuse. | |
| Motors do not move | Check the emergency stop state. The red LED on the support
module most not be on. The LED indicates emergency stop|| Deactivate emergency stop. | ||
| The modules do not react to software commands. The green LEDs are not blinking, they are continuously on | There must not be an empty slot between the support module of the electronics and the joint modules. The CAN connection is interrupted by such an empty slot. | Ensure there is no empty slot between the modules | |
| The motor stalls: it does not finish a motion and increases in pitch of sound. | This happens, when the load of the motor was too high and it stalled. | Check if there was a collision. | If this happens several times increase the motor current, see chapter 7 of the manual. |
