CAN Protocol

From Wiki

Commonplace Robotics uses the CAN field bus to send position set point values from the robot controller to the joint modules. The applied protocols are custom, but quite simple.

Two version are used

  • CPRCAN: 16 bit position data used for Mover4 and Mover6 robots and Slider platforms
  • CPRCANV2: 32 bit position data used for SRA and Mover6-2016 (understands both, CPRCAN and CPRCANV2) robots.

The position set point messages have to be send in a loop with e.g. 20 Hz. The application has to verify that this loop has a constant cycle time. If the jitter is too big the motion control modules might get into a communication loss error state. Additionally the application has to send state change messages like reset-all-errors and enable-motors.

The joint modules answer with an error code that provides the current state.

Resources:

Currently we are updating the example source code to the cprcanv2 protocol. Please get in contact if you need these sources.

Hardware / Drivers

Our robots and control electronics are usually supplied with a white PCAN USB adapter. If you have an older, black PCAN adapter, get in touch with us.

for Windows 10, 8.1, 7 (32/64-bit)

The PCAN USB Windows driver for the adapter can be found on the CPRog installation CD, if supplied, or downloaded here:

for Linux

For the ROS environment a Linux driver is required. It can be found here: