Troubleshooting Identification

From Wiki

Back to Troubleshooting...

FAQ - Standard Problems during Setup

  1. Joints do not move at all: ##Release E-Stop,
  2. A5 moves fast and does not stop
  3. False motion directions
  1. Strange XYZ coordinates
  1. Joint is moveable by hand with no electrical power applied
  1. Position lag "LAG" error
  1. Encoder "ENC" error

FAQ - Standard Cases during Operation

  1. Strong breaking noise when a joint accelerates, joint stops with error "LAG" or "ENC"
  1. Motor is too hot (> 80 Deg. C)
  1. Squeaking sound when the joint moves


Mechanics / Cables

  1. Motor does not turn
  1. Motor starts to turn, gets faster and does not stop
  1. Joint does not move continually
  1. Referencing does not terminate
  1. Referencing inconsistent

Electronics

  1. Error "Module Dead"

Wrong CAN ID

  1. No LED on the module is on

Check Power Supply

  1. Display shows jitter

Wrong CAN ID


Configuration

  1. Robot does not move in a straight line
  1. Second DIO not working

Wrong CAN ID

Programming